softwareng

Author: Ibrahim

  • Intro to Bricks

    —

    by

    Ibrahim
    in

    Brick making is mostly a village industry. Since the dawn of civilization, bricks have been made by drying in the sun. The Great Wall of China was made of both burnt and sun-dried bricks. Bricks have been used in every class and type of building all over the world. In places where clay is available…

  • Cement Storage

    —

    by

    Ibrahim
    in

    Cement naturally absorbs moisture and hardens. Therefore, proper care should be taken in storing cement. 5% moisture absorption means that the cement becomes useless and therefore the cement has to be stored in a moisture free environment. It is advised not to store cement in jute bags for more than 3 months. Cement bags should…

  • Cement Grinding

    —

    by

    Ibrahim
    in

    The clinkers obtained from the rotary kiln are finely ground in ball mills and tube mills. During grinding, a small amount, about 3-4 percent, of gypsum is added. Controls the initial setting time of gypsum cement. If gypsum is not added, water will be added at the same time as cement. After grinding, the product…

  • Burning Cement

    —

    by

    Ibrahim
    in

    Incineration is done in a rotary kiln. A rotary kiln is made up of steel tubes with a diameter of 250 to 300 cm. The length varies from 90 to 120 meters. It is laid at a gradient of 1 in 25 to 1 in 30. The kiln is supported at intervals by masonry columns.…

  • Cement Setting tim

    —

    by

    Ibrahim
    in

    When water is mixed with cement, the cement components chemically react with the water to form a complex chemical mixture. Mixing cement with water makes the cement paste sticky and gradually thickens over time. It has been found that ordinary cement attains 70 percent of its ultimate strength in 20 days and 90 percent in…

  • Harmful Cement constituents

    —

    by

    Ibrahim
    in

    The presence of alkali oxides such as K2O and Na2O and magnesium oxides such as MgO adversely affects the quality of cement. If the alkali oxide content is more than 1%, it leads to concrete failure. If the magnesium oxide content is more than 5%, it cracks after the mortar and hardens the concrete.

  • Cement Indgredient

    —

    by

    Ibrahim
    in

    Lime (CaO): The main ingredient of cement is lime. Its ratio ranges from 60 to 67 percent. Excessive lime makes the cement poor and causes the cement to spall and crack and also inhibits the setting properties. On the other hand, if lime is deficient, it reduces the strength of cement.Silica (SiO2): It constitutes 17…

  • Cement Properties

    —

    by

    Ibrahim
    in

    The properties of cement are: It gives strength to masonry.It acts as an excellent binding material.It provides good resistance to moisture. It hardens or hardens quickly.It has good plasticity.

  • Introduction to Cement

    —

    by

    Ibrahim
    in

    Natural cement is brown in color. It sets very quickly after the addition of water and is not as strong as synthetic cement, so its use is limited. cement when burnt in the usual manner. Later, several experiments with several mixtures of limestone and argillaceous were carried out so that the properties of the product…

  • Lime uses

    —

    by

    Ibrahim
    in

    Lime can be used for the following purposes: Lime Mortar: Lime mortar has been widely used in construction works since ancient times. Lime mortar is used as a building medium for brick, stone and other masonry, as well as for plastering and pointing. Depending on the composition of lime mortar for building work:Masonry type Work…